ISELFInalProjectInfo
Information about several subjects regarding the ISEL final project.
IIO
Adapted from http://wiki.analog.com/software/linux/docs/iio/iio
The Industrial I/O subsystem is intended to provide support for devices that in some sense are analog to digital or digital to analog convertors (ADCs, DACs). Devices that fall into this category are:
- ADCs
- Accelerometers
- Gyros
- IMUs
- Capacitance to Digital Converters (CDCs)
- Pressure Sensors
- Color, Light and Proximity Sensors
- Temperature Sensors
- Magnetometers
- DACs
- DDS (Direct Digital Synthesis)
- PLLs (Phase Locked Loops)
- Variable/Programmable Gain Amplifiers (VGA, PGA)
SPI
I2C
ARM AT91SAM9260B
http://www.atmel.com/devices/sam9260.aspx
A 210MHz ARM926-based processor with an extensive range of communication peripherals. It embeds FS USB host and device interfaces, a 10/100 Ethernet MAC and an image sensor interface, as well as standard peripherals such as a Multimedia Card Interface (MCI), I2S, USARTs, master/slave SPIs, 16-bit Timers, a TWI and four-channel 10-bit ADC. The external bus interface features controllers for SDRAM and static memories including NAND flash and CompactFlash. The SAM9260 is available in 217-ball LFBGA and 208-pin QFP packages.
FXOS8700CQ
http://www.freescale.com/webapp/sps/site/prod_summary.jsp?code=FXOS8700CQ
Freescale’s FXOS8700CQ 6-axis sensor combines industry leading accelerometer and magnetometer sensors in a small 3 x 3 x 1.2 mm QFN plastic package. The 14-bit accelerometer and 16-bit magnetometer are combined with a high-performance ASIC to enable an eCompass solution capable of a typical orientation resolution of 0.1 degrees and sub 5 degree compass heading accuracy for most applications.